info@enerconsupply.com
718-855-5888
Wireless Occupancy Sensor


Occupancy Sensor
Saving energy without sacrificing comfort can be effortless with occupancy-based controls. The Ceiling Mounted Occupancy Sensor enables a new level of energy saving control for rooms, hallways and other common areas.
The occupancy sensor uses radio frequency technology to communicate wirelessly with other EnergyCenter and EnOcean-enabled devices to set back temperature and turn off lights and electrical loads when a space has been unoccupied for a set period of time.
Because the sensors are wireless there is no need to run additional wiring and installation can be completed in a matter of minutes. The sensor is self-powered by harvesting energy from indoor light, eliminating the need for periodic battery changes. The clean, contemporary styling makes it an attractive addition to any décor.
Downloads:
Features:
-
Communicates wirelessly with other EnergyCenter and EnOcean devices
-
Two integrated solar cells enable indoor light energy harvesting to power the device and eliminate the need for wires or batters
-
PIR motion sensor with 360° viewing angle lens for maximum efficiency in different room settings
-
Two molded buttons with LED indicator lights can be used to link and configure the device
-
Internal coin cell battery as backup for low light environments
-
Perfect energy saving solution for any space where traffic patterns or occupancy determine the need to power the space – ideal for guest rooms, living spaces, common areas, or hallways
-
Energy harvesting wireless solution provides limitless supplies of energy and unrivaled flexibility
Product Specs:

Power Supply: Indoor light energy harvesting (Optional supplemental battery or 2-wire connector for external power or remote solar cell)
Radio Network: 902 MHz RF transceiver
Ranges:
-
Transmission Range: 80ft. (25m)
-
Motion Detection Range: 40ft. (12.5m) diameter


55C 9th St
Brooklyn, NY 11215
Email: info@enerconsupply.com
Tel: 718-855-5888
For any general inquiries, please fill in the following contact form: